POWER TAP

INSTALLATION INSTRUCTIONS

BE SAFE, DISCONNECT THE BATTERY FIRST!

This Power Tap Add-On harness is intended to "Plug-n-Play" in

between the rear fender harness as well as adds switched 12-volt

power and a ground wire for universal applications.

Start by disconnecting the 8-position Multilock connector from. the

main harness, which is located under the seat.

Connect the POWER TAP in between fender and main harness.

Once the POWER TAP is plugged in, you can begin to connect and device

that requires 12-volt power.

Once all harnesses are connected, re-connect battery & be sure that

all connections have safely made and properly secured

Test ALL functions accordingly.

Liability Limitations...

We all know that motorcycles can be very dangerous. MOTORCYCLE TUNES

has no control over how our products are used, modified and/or installed. (It is advised and recommended that all of our products are installed by a professional motorcycle mechanic. Consult your local motorcycle Dealer for more information.) MOTORCYCLE TUNES assumes no responsibility for damage or injury of any kind due to misuse,

improper installation or the improper application of any of our products by any dealership, customer or any other individual. MOTORCYCLE TUNES shall not be held

liable for any indirect of consequential damages or injuries whatsoever.

Product Warranty...

It is recommended that you consult with your motorcycle dealer before purchasing our products. Motorcycle Tunes products are guaranteed against defects in material and/or workmanship only. NOTE, extreme temperatures and excessive bending may cause the protective coating to crack. All defective merchandise will be repaired or replaced under warranty within 30 days of original purchase. MOTORCYCLE TUNES will assume not responsibility or liability for any products that have been modified, misused or abused in any way.